Closed Loop Stepper Driver
-
2S86 ZLTECH 86 series DC 36V 48V AC 27V-75V closed loop stepping driver for CNC machine
ZLTECH closed-loop stepper driver 2S86 controls DSP chip and closed-loop control technology, so as to completely overcome the problem of step loss of open-loop stepper motor. Under light load, it can significantly improve the high-speed performance of the motor, reduce the heating degree of the motor and reduce the vibration of the motor, so as to improve the processing speed and accuracy of the machine and reduce the energy consumption of the machine. In addition, when the motor is continuously overloaded, the driver will output an alarm signal, which has the same reliability as the AC servo system.
-
ZLTECH 2 phase Nema23 24-36VDC closed loop stepper driver for 3D printer
The characteristics of
- Ultra-low vibration and noise.
- Maximum 512 micro-step subdivision, minimum unit 1.
- It can drive the closed-loop stepper motor below 60.
- Input voltage: 24~60VDC.
- Output phase current: 7A(Peak).
- 3 isolated differential signal input port: 5~24VDC.
- 4 dip switch selection, 16 level subdivision.
- Single and dual pulses are supported.
- With over voltage, over current, over differential protection function.
